主桩辅桩联合修复对前磨牙应力的有限元分析

doi:10.7518/gjkq.2017.05.013

摘要/Abstract

摘要： 目的研究下颌第一前磨牙仅用纤维桩主桩和主桩与辅桩联合应用时,牙体及修复体所受应力大小分布的影响。方法选择19颗正常的离体下颌第一前磨牙,应用锥形束CT（CBCT）扫描,获取图像,选取扁形单根管前磨牙1颗,经根管治疗及桩道预备此牙后,再次以相同条件进行CBCT扫描,利用三维有限元法建立只应用主桩的分析模型A及主桩与辅桩联合应用的模型B,分析不同载荷情况下牙体和修复体上的应力大小及分布情况。结果当受到与牙体长轴成相同角度的载荷时,模型A和模型B的牙体组织和桩上的应力大小及分布无明显差异。同等大小的载荷,随着加载角度增大,模型A和模型B牙体组织上应力均明显增大。结论辅桩对修复体应力的影响不大,但随着加载角度的增大,修复体上应力明显增大。

关键词: 三维有限元, 应力, 纤维桩主桩, 纤维桩辅桩, 前磨牙

Abstract: Objective This study aims to compare stresses of the mandibular first premolar restored with master fiber post only or combined with auxiliary fiber post.Methods A total of 19 normal mandibular first premolars were selected and scanned by cone-beam computed tomography(CBCT). Premolars with flat root canal were selected and treated using standard randomized controlled trial procedures and post-space preparation. Then, a repeat CBCT scan was conducted on the prepared tooth. Three-dimensional models were established according to results of CBCT scan. The model using the master fiber post only was named A, and another model that used master fiber post in combination with auxiliary post was labeled B. Two models were loaded in three different directions, and corresponding stress distributions were analyzed. Results After comparing A and B, results showed that stress distribution between tooth tissue and fiber post features no significant difference with loading force angle and long axis of tooth. Peak value of von Mises stress in models A and B increased significantly as loading angle increased.Conclusion Auxiliary fiber post poses minimal influence on premolar restoration after exposure to stress. However, this influence intensifies on loading angles.

Key words: three-dimensional finite element analysis, stress, master fibre post, auxiliary fibre post, premolar

中图分类号:

R781.05

张晓, 邓青完, 杜琼, 谢静. 主桩辅桩联合修复对前磨牙应力的有限元分析[J]. 国际口腔医学杂志, 2017, 44(5): 559-565.

Zhang Xiao, Deng Qingwan, Du Qiong, Xie Jing. Three-dimensional finite element analysis of premolars restored with master fiber post-combined with auxiliary fiber post[J]. Inter J Stomatol, 2017, 44(5): 559-565.

参考文献

[1] Akgungor G, Akkayan B. Influence of dentin bon-ding agents and polymerization modes on the bond strength between translucent fiber posts and three dentin regions within a post space[J]. J Prosthet Dent, 2006, 95(5):368-378.
[2] D’Arcangelo C, Cinelli M, De Angelis F, et al. The effect of resin cement film thickness on the pullout strength of a fiber-reinforced post system[J]. J Prosthet Dent, 2007, 98(3):193-198.
[3] 皮昕. 口腔解剖生理学[M]. 北京: 人民卫生出版社, 2007:41.
Pi X. Oral anatomy and physiology[M]. Beijing: Peple’s Medical Publishing House, 2007:41.
[4] 宋亮. 桩核冠修复不同程度缺损下颌前磨牙的三维有限元分析[J].口腔医学研究, 2015, 31(10): 1013-1016.
Song L. There dimensional finite element analysis of defected mandibular premolar restored with post and core crown[J]. J Oral Sci Res, 2015, 31(10):1013- 1016.
[5] 周冰. 下颌前磨牙桩核冠的有限元分析[D]. 西安: 第四军医大学, 2005.
Zhou B. The finite analysis of mandible premolar restored with post-and-core crown[D]. Xi’an: The Fourth Military Medical University, 2005.
[6] 康成容, 魏素华, 张美超, 等. 纤维桩修复上颌中切牙的三维有限元研究[J]. 华西口腔医学杂志, 2008, 26(4):430-434.
Kang CR, Wei SH, Zhang MC, et al. A three dime-nsional finite element study on stress distribution in maxillary central incisor restored with fiber post[J]. West Chin J Stomatol, 2008, 26(4):430-434.
[7] 张娜, 封纯真, 赵守亮, 等. 根管锥度和根管固位材料对牙体组织应力分布影响的三维有限元分析[J]. 中华口腔医学杂志, 2011, 46(3):153-156.
Zhang N, Feng CZ, Zhao SL, et al. Three-dimen-sional finite element analysis of effect of root canal taper and post on tooth stress distribution[J]. Chin J Stomatol, 2011, 46(3):153-156.
[8] 李丽君. 不同桩核系统修复磨牙牙体缺损的有限元与临床研究[D]. 广州: 中山大学, 2010.
Li LJ. Finite element analysis and clinical trail of endodonticany treated molars restored with different post and core material[D]. Guangzhou: Sun Yat-sen University, 2010.
[9] 吴菲, 李晓娜, 陈琳, 等. 桩核材料对牙本质应力分布影响的三维有限元分析[J]. 中国煤炭工业医学杂志, 2006, 9(7):708-710.
Wu F, Li XN, Chen L, et al. Three-dimensional finite element analysis of effect of the material on the dis-tribution of the essential stress of the teeth[J]. Chin J Coal Indust Med, 2006, 9(7):708-710.
[10] Romeed SA, Dunne SM. Stress analysis of different post-luting systems: a three-dimensional finate ele-ment analysis[J]. Aust Dent J, 2013, 58(1):82-88.
[11] Ona M, Wakabayashi N, Yamazaki T, et al. The in- fluence of elastic modulus mismatch between tooth and post and core restorations on root fracture[J]. Int Endod J, 2013, 46(1):47-52.
[12] 张强. 不同桩核修复系统对喇叭口状残根修复后牙齿抗折性能的影响[D]. 济南: 山东大学, 2007.
Zhang Q. The fracture resistance of flared root canal tooth restored with different post systems[D]. Jinan: Shandong University, 2007.
[13] 谭建国. 牙齿美学修复的美学桩核[J]. 中国实用口腔科杂志, 2011, 4(8):464-465.
Tan JG. Esthetic post and core in dental esthetic rehabilitation[J]. Chin J Pract Stomatol, 2011, 4(8): 464-465.
[14] 孟庆飞, 陈丽娟, 孟箭. 不同桩核材质和牙本质肩领对前牙残根修复效果影响的临床研究[J]. 口腔医学研究杂志, 2014, 30(7):642-644.
Meng QF, Chen LJ, Meng J. A clinical study on the effect of different post-core material and dentin shoulder on the restoration of anterior teeth[J]. Chin J Stomatol Res, 2014, 30(7):642-644.
[15] 张文云, 王琳, 杨立斗, 等. 粘结层厚度对纤维桩在根管内剪切粘结强度的影响[J]. 牙体牙髓牙周病学杂志, 2011, 21(9):494-498.
Zhang WY, Wang L, Yang LD, et al. Effect of cement film thickness on the bond strength of fiber post in the root canal[J]. Chin J Conserv Dent, 2011, 21(9): 494-498.

相关文章 15

[1]	孙晓倩, 张军. 机械力环境影响头颈癌生物学行为及作用机制的研究进展[J]. 国际口腔医学杂志, 2023, 50(4): 414-418.
[2]	方苓力,谭玺,叶雨丝,黄兰,何瑶. 颞下颌关节退行性变早期髁突软骨细胞行为改变的实验研究[J]. 国际口腔医学杂志, 2021, 48(4): 417-425.
[3]	孟秀萍,侯建华,李怡然,孙梦瑶. 龈壁提升术材料选择及边缘设计的研究进展[J]. 国际口腔医学杂志, 2021, 48(3): 280-286.
[4]	李静雅,税钰森,郭永文. 循环牵张应力影响人牙周膜细胞成骨分化机制的研究进展[J]. 国际口腔医学杂志, 2020, 47(6): 652-660.
[5]	陈昕,毛渤淳,鲁雨晴,董博,朱卓立,岳莉,于海洋. 钴铬合金和聚醚醚酮用于可摘局部义齿支架的三维有限元分析[J]. 国际口腔医学杂志, 2019, 46(5): 526-531.
[6]	颜丹,张锡忠,王建国. 螺纹深度对支抗微种植体和颌骨影响的三维有限元分析[J]. 国际口腔医学杂志, 2019, 46(4): 387-392.
[7]	黄璐,钱捷. 三维有限元在嵌体修复中的研究进展[J]. 国际口腔医学杂志, 2018, 45(6): 728-733.
[8]	曾婷艳, 黄生高. 种植体支抗稳定性的三维有限元分析[J]. 国际口腔医学杂志, 2018, 45(1): 112-118.
[9]	曹国庆, 王林霞, 杜莉平. 有限元法在桩核冠修复研究中的应用[J]. 国际口腔医学杂志, 2017, 44(2): 209-213.
[10]	单知一徐子卿沈刚. 三维有限元法在舌侧正畸矫治领域中的应用[J]. 国际口腔医学杂志, 2016, 43(5): 560-564.
[11]	林春平1 董跟喜1 李永锋2 李鹏博2. 兰州市成人离体前磨牙的解剖形态研究[J]. 国际口腔医学杂志, 2015, 42(6): 643-646.
[12]	王波1 张桂香2 石晶3 彭惠3 张莹3. 自锁托槽矫治器矫治初期上颌异位侧切牙及牙周组织应力的三维有限元分析[J]. 国际口腔医学杂志, 2015, 42(4): 406-410.
[13]	胡艺蝶周力王艳民. 拔牙矫治与下颌第三磨牙萌出状况的关系[J]. 国际口腔医学杂志, 2015, 42(3): 367-370.
[14]	关卿金涛顾永春杨犇倪龙兴. 3种根管预备器械在弯曲根管中扭转负载下的三维有限元分析[J]. 国际口腔医学杂志, 2015, 42(3): 269-272.
[15]	周妮张灿华李艳红刘娟. 下颌前磨牙区多颗多生牙1例[J]. 国际口腔医学杂志, 2014, 41(1): 20-22.

Metrics

Viewed

Full text

Abstract

Cited

Shared

Discussed