国际口腔医学杂志 ›› 2010, Vol. 37 ›› Issue (02): 150-150~153.doi: 10.3969/j.issn.1673-5749.2010.02.007

• 论著 • 上一篇    下一篇

金属加强结构对后牙4 单位金属烤瓷固定桥强度的影响

陈铭晟1,孟玉坤1,徐江2,李中杰1   

  1. 1.口腔疾病研究国家重点实验室, 四川大学 四川 成都 610041
    2.新疆医科大学附属
  • 收稿日期:2009-09-08 修回日期:2009-12-07 出版日期:2010-03-20 发布日期:2010-03-20
  • 通讯作者: 孟玉坤

nfluence of reinforcement designs in metal frameworks on the strength of veneerin

CHEN Ming-sheng1, MENG Yu-kun1, XU Jiang2, LI Zhong-jie1   

  1. 1. State Key Laboratory of Oral Diseases, Sichuan University, Chengdu 610041, Chi
  • Received:2009-09-08 Revised:2009-12-07 Online:2010-03-20 Published:2010-03-20
  • Contact: MENG Yu-kun

摘要: 目的 比较不同桥体加强结构设计对烤瓷固定桥瓷层强度的影响,为临床使用合适的金属桥架设计提供参考。方法 对C5、C6 缺失采用C4-C7 金属烤瓷双端固定桥模型,在烤瓷固定桥金属基底的舌侧设计点状和带状加强结构,以无加强结构设计作为对照,在桥体中央垂直于咬合面进行加载(速度0.5 mm·min-1),记录饰面瓷破坏时的载荷以及破坏的形式。采用SPSS 11.0 软件进行统计分析,比较瓷层失败时的最大载荷值组间差异(α=0.05),并探讨不同设计组间瓷层破坏形式的差异。结果 3 种不同设计组发生瓷裂时的平均最大载荷分别为(0.87±0.06)kN(无加强结构)、(1.03±0.15)kN(点状加强结构)和(0.93±0.10)kN(带状加强结构)。无加强
结构组与点状加强带组的最大载荷差异具有统计学意义(P<0.05),其他组间差异无统计学意义(P>0.05)。在瓷层破坏形式上,各组间没有明显的差异,瓷层破坏的位置几乎都是在加载点周围和近远中固位体的连接体部位。结论 金属桥架舌侧连接体区的点状加强结构对烤瓷桥强度可以起到明显的增强效果。

关键词: 固定桥, 金属支架设计, 瓷层破坏, 强度

Abstract: Objective To compare the effect of 3 different reinforcement designs in the metal frameworks on the strength of veneering porcelain of 4-unit metal-ceramic fixed bridges by means of load-to-failure method. Methods 4-unit metal-ceramic fixed bridges with contiguous missing of C5 and C6, with C4 and C7 as abutments
were fabricated, with 3 different reinforcement designs of the metal frameworks: Non-reinforcement, lingual punctuate metal reinforcement, and lingual linear metal reinforcement. After cementation of the bridge, vertical loads were then applied on the occlusal surface at the center of the pontics on a testing machine(at a crosshead speed of 0.5 mm·min-1) until the first sign of porcelain crack appeared. Load-to-failure forces and modes of porcelain failure were recorded. The load-to-failure forces among the three different reinforcement design groups were statistically analyzed with SPSS 11.0 software, using one-way ANOVA and SNK comparison(α=0.05), and the modes of porcelain failure were also compared. Results The load-to-failure forces of the bridges in the three reinforcement design groups were(0.87 ±0.06)kN(non -reinforcement), (1.03 ±0.15)kN(lingual punctate metal reinforcement), and(0.93±0.10)kN(lingual linear metal reinforcement) respectively. Significant difference was found between non-reinforcement and lingual punctate metal reinforcement group(P <0.05), while no significant difference was found between the other groups(P >0.05). The modes of porcelain fracture were about the same in the three
groups. Conclusion The bridges with punctuate reinforcement demonstrated the maximal load-to-failure forces.

Key words: fixed partial denture, framework design, porcelain failure, strength

中图分类号: 

  • R
[1] 刘昱晨,田敏,牛丽娜,方明. 粘接固定桥存留率的影响因素及提高对策[J]. 国际口腔医学杂志, 2021, 48(5): 585-591.
[2] 陈西文 周进茹 朱智敏. 粘接固定桥的固位及研究进展[J]. 国际口腔医学杂志, 2016, 43(5): 537-541.
[3] 林捷1 郑智烽2 卢兆杰1 李秀容2 郑志强1. 后牙氧化锆树脂粘接固定桥的设计和粘接技巧[J]. 国际口腔医学杂志, 2015, 42(6): 624-627.
[4] 张兴乐 李磊 李乐 王鹏 周延民. 骨质量对精密附着体天然牙-种植体联合固定桥的应力影响[J]. 国际口腔医学杂志, 2013, 40(1): 14-16.
[5] 张雯综述 郑美华审校. 全瓷固定桥抗折性能的研究进展[J]. 国际口腔医学杂志, 2010, 37(4): 481-484.
[6] 高文玲综述 夏海斌, 李智勇审校. 全瓷固定桥的研究进展[J]. 国际口腔医学杂志, 2008, 35(4): 471-471~473.
[7] 汪振华,王金玉,袁祥民. 固定桥对口腔微生态系影响的研究现状[J]. 国际口腔医学杂志, 2005, 32(02): 159-160.
[8] 牛林. 单端固定桥及支持组织应力分布的研究进展[J]. 国际口腔医学杂志, 2004, 31(S1): -.
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] 张新春. 桩冠修复与无髓牙的保护[J]. 国际口腔医学杂志, 1999, 26(06): .
[2] 王昆润. 长期单侧鼻呼吸对头颅发育有不利影响[J]. 国际口腔医学杂志, 1999, 26(05): .
[3] 彭国光. 颈淋巴清扫术中颈交感神经干的解剖变异[J]. 国际口腔医学杂志, 1999, 26(05): .
[4] 杨凯. 淋巴化疗的药物运载系统及其应用现状[J]. 国际口腔医学杂志, 1999, 26(05): .
[5] 康非吾. 种植义齿下部结构生物力学研究进展[J]. 国际口腔医学杂志, 1999, 26(05): .
[6] 柴枫. 可摘局部义齿用Co-Cr合金的激光焊接[J]. 国际口腔医学杂志, 1999, 26(04): .
[7] 孟姝,吴亚菲,杨禾. 伴放线放线杆菌产生的细胞致死膨胀毒素及其与牙周病的关系[J]. 国际口腔医学杂志, 2005, 32(06): 458 -460 .
[8] 费晓露,丁一,徐屹. 牙周可疑致病菌对口腔黏膜上皮的粘附和侵入[J]. 国际口腔医学杂志, 2005, 32(06): 452 -454 .
[9] 赵兴福,黄晓晶. 变形链球菌蛋白组学研究进展[J]. 国际口腔医学杂志, 2008, 35(S1): .
[10] 庞莉苹,姚江武. 抛光和上釉对陶瓷表面粗糙度、挠曲强度及磨损性能的影响[J]. 国际口腔医学杂志, 2008, 35(S1): .

蜀ICP备09013973号-3
版权所有 © 《国际口腔医学杂志》编辑部
地址:四川成都人民南路三段14号 邮编:610041
电话:028-85502414 E-mail:gwyxkqyxfc@vip.163.com